PanelFix timber screws with countersunk milling head, cutting notch, zinc-plated steel, with ETA-11/0389 approval from dia. 3.5 mm
PanelFix timber screw with csk. head, zinc-plated steel, ETA-11/0389 3.5x30
Simple countersinking of the head using milling ribs, no pre-countersinking of the wood required.
The cutting notch pre-drills and reduces the splitting effect of the wood.
The cutting notch pre-drills and reduces the splitting effect of the wood.
Simple countersinking of the head using milling ribs, no pre-countersinking of the wood required.
The cutting notch pre-drills and reduces the splitting effect of the wood.
Application area:
- Rafter attachments
- Insulation on rafters
- Beam attachments
- Eave beam attachment
- Roof constructions
- Wooden house construction
- Balcony construction
- Pergolas
- Winter gardens
- Canopies
- Staircase construction
- Couplings
- Carports
- Games and gymnastics apparatus
- Furniture construction
- etc.
Field of Application:
Universal use, interior finishing, construction of roofs, furniture and prefabricated elements, structural timber work, rafter insulation, everywhere where chipboard and timber screws are used.
Advantages:
- ETA approval from dia. 3.5 mm
- Coarse thread reduces the screw-in time.
- Countersunk milling head for the countersinking of the head in wood.
- High strength due to the use of special carbon steel and additional hardening.
- The cutting notch pre-drills and reduces the splitting effect of the wood
- Thread cutting grooves for better removal of sawdust
- End mill (only for partial threaded screws) reduces the screw-in torque.
Advice:
When fixing roof-mounted insulation systems, no pre-drilling of the rafters is required and the screws are screwed through the securing battens placed above the insulation material and through the insulation material into the rafters in a single step.
When fixing screws in wooden components, the screw heads should be flush with the surface of the wooden component and without the head section in the case of washer head screws.
Datasheets(X)
 | |
Diameter | 3.5 mm |
Length | 30 mm |
Head type | Countersunk milling head |
Head diameter | 7 mm |
Internal drive | TX20 |
End milling cutter | No |
Thread type | Wood screw thread |
Thread design | Full thread |
Material | Steel |
Surface | Zinc plated |
Last viewed
Particle board screws A2
Hexagon nut DIN 934 strength class 8, zinc-plated - small packs
Drywall screws for fibreboard with HiLo thread - tradesperson packs
PE protective film, blue
Chipboard screws, zinc plated yellow
Hexagon head wood screw, DIN 571, galvanised
Particle board screws, galvanised
ACP nail anchor L2 - 200 pieces/pack
Insulation anchor with plastic nail
Duct tape, fabric-reinforced