PanelFix timber screw with washer head, cutting notch, zinc-plated steel, with ETA-11/0389 approval
PanelFix timber screw with washer head, zinc-plated steel, 6.0x160/70
The washer head increases the pull-through values many times over and saves the additional use of washers.
The cutting notch pre-drills and reduces the splitting effect of the wood.
The cutting notch pre-drills and reduces the splitting effect of the wood.
The washer head increases the pull-through values many times over and saves the additional use of washers.
The cutting notch pre-drills and reduces the splitting effect of the wood.
Application area:
- Rafter attachments
- Insulation on rafters
- Beam attachments
- Eave beam attachment
- Roof constructions
- Wooden house construction
- Balcony construction
- Pergolas
- Winter gardens
- Canopies
- Staircase construction
- Couplings
- Carports
- Games and gymnastics apparatus
- etc.
Field of Application:
Insulation on rafters, structural wood construction, element construction, timber panel construction, interior finishing. For all applications in which timber screws are used.
Advantages:
- Coarse thread reduces the screw-in time.
- Washer head increases the head pull-through values and saves the additional use of washers.
- High strength due to the use of special carbon steel and additional hardening.
- The cutting notch pre-drills and reduces the splitting effect of the wood
- Thread cutting grooves for better removal of sawdust
- End mill (only for partial threaded screws) reduces the screw-in torque.
Advice:
When fixing roof-mounted insulation systems, no pre-drilling of the rafters is required and the screws are screwed through the securing battens placed above the insulation material and through the insulation material into the rafters in a single step.
When fixing screws in wooden components, the screw heads should be flush with the surface of the wooden component and without the head section in the case of washer head screws.
Datasheets(X)
 | |
Diameter | 6 mm |
Length | 160 mm |
Thread length (thread for woodwork) | 70 mm |
Head type | Round washer head |
Head diameter | 14 mm |
Internal drive | TX30 |
End milling cutter | Yes |
Thread type | Wood screw thread |
Thread design | Partial thread |
Material | Steel |
Surface | Zinc plated |
Last viewed
Insulation anchor with plastic nail
Stud anchor B, galvanised
Drywall screws with Teks drill tip, special length - tradesperson packs
Dia. 3.9 - 5.0 mm drywall screws, single-start thread - tradesperson packs
Dia. 3.9-5.0 mm drywall screws, double-start thread - small packs
Drilling screw with large washer head, dia. 11 mm
Adhesive tape, soft PVC
PanelFix timber screws with countersunk milling head, cutting notch, zinc-plated steel, with ETA-11/0389 approval from dia. 3.5 mm
MONTAPE - Joint and partition wall tape
Drywall screw for plasterboard with punching head and underhead counter thread with needle tip - tradesperson packs